Table of Contents
Advertisement
About this task
Below is a list of options/steps available:
Steps
1. Restore the service tag, license, and diagnostics information, press Y
2. Navigate to the Lifecycle Controller based restore options, press N
3. Restore data from a previously created Hardware Server Profile, press F10
NOTE:
When the restore process is complete, BIOS prompts to restore the system configuration data.
4. Restore data from a previously created Hardware Server Profile, press F10
5. To restore the system configuration data, press Y
6. To use the default configuration settings, press N
NOTE:
After the restore process is complete, system reboots.
Manually update the Service Tag
After replacing a system board, if Easy Restore fails, follow this process to manually enter the Service Tag, using System
Setup.
About this task
If you know the system service tag, use the System Setup menu to enter the service tag.
Steps
1. Power on the system.
2. To enter the System Setup, press F2.
3. Click Service Tag Settings.
4. Enter the service tag.
NOTE:
You can enter the service tag only when the Service Tag field is empty. Ensure that you enter the correct
service tag. Once the service tag is entered, it cannot be updated or changed. Incorrectly entered service tag will lead to
system board replacement.
5. Click OK.
Sliding out the system board tray for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the storage
tray.
4.
Remove the
risers.
5.
Remove the VSB cables from the system
6.
Remove lower brace
cover.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling
diagram.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
Steps
1. Unlock all the four blue plungers on the system board tray. Rotate the handle upward, and then lock the two blue plungers
near to the handle.
2. Slide the system board tray toward the rear of the chassis until it locks at its position.
Safety
instructions.
Before working inside your
board.
system.
Installing and removing system components
157
Advertisement
Table of Contents
