Removing The Sensor Tray For Intel Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

3. Install the lower brace
4. Reconnect all the cables onto the system board. For more information, see
5. Install the risers.
6. Install the storage tray.
7. Install the VSB cables on the system
8. Follow the procedure listed in the
.

Removing the sensor tray for Intel GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the storage tray.
4. Remove the risers.
5. Remove the VSB cables from the system
6. Remove lower brace cover.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
9. Slide out the system board
10. Make sure to wear gloves for remove sensor tray to prevent hands touch sensor cables directly.
Figure 186.
11. Do not touch the sensor tray cable directly.
190 Installing and removing system components
cover.
board.
After working inside your
Safety
Before working inside your system
board.
tray.
system.
instructions.
.
Cabling diagram.