Installing The Liquid Cooling Manifold - Dell PowerEdge XE9640 Installation And Service Manual

Figure 284. Removing the liquid cooling manifold
Next steps
Replace the liquid cooling

Installing the Liquid cooling Manifold

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. For NVIDIA configurations:.
a. Disconnect the cables from the connector on the system board and the storage tray.
b. Remove the VSB from the system board
c. Remove the storage
d. Remove the risers
PSB.
e. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
f. Remove the lower brace
g. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and
make sure do not damage any connectors on the system board.
h. Slide out the system board
i. Unplug the GPU cold plate tubes from the Manifold liquid cooling module.
j. Remove the System board
k. Disconnect all the liquid cooling tubes from the Manifold.
4. For Intel GPU configurations:
a. Remove the storage
b. Remove the risers.
c. Remove the VSB cables from the system
d. Remove lower brace
manifold.
Safety
Before working inside your system
and keep it on the storage tray and no need to disconnect from the PDB2.
tray.
and keep the risers away from the system board tray and no need to disconnect the cables from the
bracket.
tray.
tray.
tray.
board.
cover.
instructions.
.
Installing and removing system components 253