Manifold Module; Removing The Manifold Module - Dell PowerEdge XE9640 Installation And Service Manual

Figure 282. Installing the GPU module
Next steps
1. Install the GPU cold plate.
2. Install the sensor tray.
3. Plug the cold plate tubes to the Manifold Liquid cooling module.
4. Slide in the system board
5. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
6. Install the lower brace
7. Reconnect all the cables onto the system board. For more information, see
8. Install the risers.
9. Install the storage tray
10. Install the VSB cables on the system
11. Follow the procedure listed in the

Manifold module

This is a service technician replaceable part only.

Removing the Manifold module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. For NVIDIA configurations:.
● Disconnect the cables from the connector on the system board and the storage tray.
● Remove the VSB from the system board
● Remove the storage
● Remove the risers
PSB.
● Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
● Remove the lower brace
● Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and
make sure do not damage any connectors on the system board.
tray.
bracket.
.
board.
After working inside your
Safety
Before working inside your system
and keep it on the storage tray and no need to disconnect from the PDB2.
tray.
and keep the risers away from the system board tray and no need to disconnect the cables from the
bracket.
system.
instructions.
.
Installing and removing system components
Cabling diagram.
251