Installing The Lower Brace Cover For Nvidia Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

Figure 115. Removing the lower brace bracket
Next steps
Replace the lower brace for NVIDIA GPU

Installing the lower brace cover for NVIDIA GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the cable cover.
4. Observe and disconnect the intrusion switch bridge cable from the connectors on the storage tray that is connected from
the system board. Observe and disconnect the drive backplane cables, BOSS power and signal cables, fan board cables from
the connector on the storage tray, signal cable from the connectors on the PDB2 and then keep the cables away from the
storage tray. Disconnect the VSB power cables (left and Right) from the connector on the system board and keep them on
the storage tray.
5. Remove the storage tray.
Steps
Align the lower brace cover on the lower brace along the arrow, using two fingers press the touch point on the lower brace
cover until it firmly seated on the lower brace.
configurations.
Safety instructions.
Before working inside your system .
Installing and removing system components 135