Lower Brace Cover; Removing The Lower Brace Cover For Intel Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

Figure 112. Installing the expansion card in to the riser
Next steps
1. If applicable, connect the cables to the expansion card.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

Lower brace cover

This is a service technician replaceable part only.

Removing the lower brace cover for Intel GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the cable cover.
4. Observe and disconnect the intrusion switch cable from the storage tray that is connected from the system board.
Disconnect the drive backplane cables, BOSS power and signal cables, fan board cables from the connectors of the storage
tray and keep the cables away from the storage tray.
5. Remove the storage tray.
Steps
Using two fingers press the touch point on the lower brace cover to release it from the lower brace.
132 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your system
system.
.