Table of Contents
Advertisement
3Installing the option devices
Fig. 3-1
and
Fig. 3-2
connection procedures. The installation procedures are as follow. This work must be carried out with the
controller power turned OFF.
1) Remove the hexagon socket bolts (five M4 x 10) and truss screw (three M3 x 8) that hold the No. 2 arm cover
B <2>, and then remove both the No. 2 arm cover B <2>.
2) Remove the socket bolts <4> (four M4 x 8) that hold the No. 2 arm cover C <3>, and then remove both the No.
2 arm cover C <3>.
3) If you are not using the spare line (ADD: stored in a coil) in section A shown in
line is connected to a connector inside section A.
Connector storage position
Fig.3-2 ： Solenoid valve installation diagram details 1
4) The length of the two air hoses (φ6) stored in section A is longer than necessary by assuming the use of a
solenoid valve set not manufactured by Mitsubishi. Cut off the air hoses to an appropriate length, and connect
them to the couplings.
5) Of the two air hoses (φ6), the one marked with "AIR IN" is for connecting the quick coupling (P port) <6> of
the solenoid valves, and the other marked with "RETURN" is for connecting the quick coupling (R port) <7> of
the solenoid valves.
6) Using the screw holes of the No. 2 arm cover C <3>, mount the solenoid valves with the socket bolts (four M4
x 8) attached to the solenoid valves. When mounting the solenoid valves, be careful not to damage the sponge
sealing material attached to the opening of section A. If the sealing material is damaged, it may degrade the
protection specification.
7) Connect the connectors of GR1 to GR2 stored in section A to the plugs of GR1 to GR2 coming out of the
solenoid valves. Store the connectors near the location marked with ○ shown in
view when stored.
Installing the solenoid valve set (1S-VD01-02/VD02-02/VD03-02/VD04-02)
3-32
shows the solenoid valve installation procedures and the solenoid valve connector
No.2 arm
View from No. 2 arm cover B side
Get other manuals https://www.bkmanuals.com
Fig.
3-1, remove it. The spare
Solenoid valve
Cut to an appropriate length
Fig.
3-2.
Fig. 3-2
shows a
Advertisement
Table of Contents
