Table of Contents
Advertisement
Figure 43. Flash power module removal
a.
Gently pivot the retaining clip as shown.
b.
Lift the flash power module up and remove it from the holder.
Remove the air baffle
Follow this procedure to remove the air baffle.
About this task
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
S017
CAUTION:
Hazardous moving fan blades nearby. Keep fingers and other body parts away.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• If the server is in a rack, remove it from the rack.
• If foot stands are installed on the server, rotate them inwards and lay the server on its side for easier
operation.
Watch the procedure. A video of the installation and removal process is available:
.
Chapter 4
Server hardware setup
89
Advertisement
Table of Contents
