Table of Contents
Advertisement
• If the server is in a rack, remove it from the rack.
• If foot stands are installed on the server, rotate them inwards and lay the server on its side for easier
operation.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Remove the front bezel.
Figure 41. Front bezel removal
a.
Lift the three plastic tabs to release the left side of the bezel from the chassis.
b.
Pivot the bezel as shown to remove it from the chassis.
Remove a flash power module
Follow this procedure to remove a flash power module.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
.
Chapter 4
Server hardware setup
87
Advertisement
Table of Contents
