Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Make sure that all cables inside the server have been properly routed so that they will not interfere
with the air baffle. See Chapter 3 "Internal cable routing" on page 47.
Figure 91. Air baffle installation
Step 2.
Align the tabs on the air baffle with the corresponding slots on the rear of the chassis and the fan
cage; then, lower the air baffle into the chassis and press the air baffle down until it is securely
seated.
Install a flash power module
Use this information to install a flash power module.
About this task
S002
CAUTION:
.
Chapter 4
Server hardware setup
137