Table of Contents
Advertisement
Step 3.
Connect the power cable and the signal cable to the system board. See "M.2 boot adapter cable
routing" on page 51.
Adjust the retainer on the M.2 boot adapter
Use this information to adjust the retainer on the M.2 boot adapter.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Before adjusting the retainer on the M.2 boot adapter, locate the correct keyhole that the retainer should be
installed into to accommodate the particular size of the M.2 drive you wish to install.
Note: The M.2 boot adapter might be different from the following illustrations, but the adjustment method is
the same.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Adjust the retainer on the M.2 boot adapter.
.
Chapter 4
Server hardware setup
121
Advertisement
Table of Contents
