Table of Contents
Advertisement
Step 5.
Hold the optical drive or tape drive in the correct orientation; then, slide it into the drive bay until it
snaps into position.
Figure 56. Optical drive installation
Step 6.
Connect the power cable and the signal cable to the rear of the optical drive or tape drive. See
"Optical drive cable routing" on page 52 or "Tape drive cable routing" on page 54.
Install the 5.25-inch drive bay adapter assembly
Use this information to install the 5.25-inch drive bay adapter assembly.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
.
Chapter 4
Server hardware setup
101
Advertisement
Table of Contents
