Table of Contents
Advertisement
Figure 93. Flash power module installation
a.
Note the orientation of the flash power module; then, gently insert the flash power module
into the retaining clip at one side as shown.
b.
Press the flash power module down on the other side until it snaps into place.
Step 2.
Connect the flash power module cable to the RAID adapter.
Install the front bezel
Use this information to install the front bezel.
About this task
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Install the front bezel.
.
Chapter 4
Server hardware setup
139
Advertisement
Table of Contents
