Table of Contents
Advertisement
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1.
Install the backplane.
Figure 61. Installation of the 2.5-inch hot-swap drive backplane
a.
Insert the backplane into the backplane slot as shown.
b.
Carefully rotate the edge of the new backplane toward the drive cage until it is secured by
the release tabs.
Install a 3.5-inch hot-swap drive backplane
Use this information to install a 3.5-inch hot-swap drive backplane.
About this task
S002
.
Chapter 4
Server hardware setup
105
Advertisement
Table of Contents
