Install A 2.5-Inch Drive Into A 3.5-Inch Drive; Bay - Lenovo ThinkSystem ST650 V2 Setup Manual

Install a 2.5-inch drive into a 3.5-inch drive bay
Use this information to install a 2.5-inch drive into a 3.5-inch drive bay.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://youtube.com/playlist?list=PLYV5R7hVcs-DoEcxrm2zKNpaKOdZ3f8Qc
• Youku:
https://list.youku.com/albumlist/show/id_59636516
Procedure
Step 1. Position the 2.5-inch drive into the 2.5-inch to 3.5-inch drive adapter.
Step 2. Align the two screw holes in the drive with the corresponding holes in the drive adapter; then, install
the two screws to secure the drive to the drive adapter.
Figure 64. 2.5-inch drive installation to drive adapter
ThinkSystem ST650 V2 Setup Guide
108