Table of Contents
Advertisement
Figure 85. Full-length GPU adapter installation
Note: Make sure the PCIe adapter retainer is in the opened position.
a.
Connect the power cable to the full-length GPU adapter.
b.
Align the full-length GPU adapter to the PCIe adapter holder and the PCIe slot; then, gently
press both ends of the full-length GPU adapter until it is securely seated in the PCIe slot.
c.
Close the PCIe adapter retainer.
After you finish
If you have installed one double-wide GPU adapter in PCIe slot 1, or three double-wide GPU adapters in
PCIe slot 1, 3, and 7; install a GPU filler. See "Install a GPU filler" on page 133.
Install an NVLink bridge
Use this information to install an NVLink bridge.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
.
Chapter 4
Server hardware setup
131
Advertisement
Table of Contents
