Install The Internal Cff Adapter - Lenovo ThinkSystem ST650 V2 Setup Manual

Figure 67. Hot-swap drive installation
a. Ensure that the tray handle is in the open position. Slide the drive into the drive bay until it
snaps into position.
b. Close the tray handle to lock the drive in place.
After you finish
1. Install other drives or drive fillers if necessary.
Note: All the drive bays must be occupied. This means that each bay must have a drive or drive filler
installed.
2. Close the front door; then, use the key to lock the server cover.
3. Check the drive LEDs to verify that the drive is operating correctly.
Drive LED
Drive activity LED (top)
Drive status LED (bottom)
4. Use the Lenovo XClarity Provisioning Manager to configure the RAID if necessary. For more information,
see:
http://sysmgt.lenovofiles.com/help/index.jsp?topic=%2FLXPM%2FRAID_setup.html

Install the internal CFF adapter

Use this information to install the internal CFF RAID adapter, internal CFF HBA adapter, or internal CFF RAID
expander adapter.
About this task
S002
ThinkSystem ST650 V2 Setup Guide
112
Status
Solid green
Blinking green
Solid yellow
Blinking yellow (blinking slowly, about
one flash per second)
Blinking yellow (blinking rapidly, about
four flashes per second)
Description
The drive is powered but not active.
The drive is active.
The drive has an error.
The drive is being rebuilt.
The RAID adapter is locating the drive.