Table of Contents
Advertisement
Figure 77. M.2 retainer adjustment
a.
Press both sides of the retainers.
b.
Move the retainer forward until it is in the large opening of the keyhole.
c.
Take the retainer out of the keyhole.
d.
Insert the retainer into the correct keyhole.
e.
Press both sides of the retainer.
f.
Slide the retainer backwards until it is seated in place.
Install an M.2 drive
Use this information to install an M.2 drive.
About this task
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read "Installation guidelines" on page 58 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Locate the M.2 drive slot on the M.2 adapter.
ThinkSystem ST650 V2 Setup Guide
122
Advertisement
Table of Contents
