Advertisement
11. Checking the robot controller operation
11. Checking the robot controller operation
This section explains how to check the controller operation using a special connector that
comes with the controller and an applicable robot. Before beginning this check, finish
making connections to the following items.
• Power supply (Do not supply power until you actually begin the operation check.)
• Robot cable
Chapter
3
• RPB programming box
• Regenerative unit (if needed)
• SAFETY connector (supplied)
(Pins 1 and 10 are shorted, pins 2, 3, 11 and 14 are shorted, and pins 12 and 13 are
shorted in the SAFETY connector.)
The connection status of emergency stop input signal is described in detail in Chapter
6, "SAFETY I/O interface".
11.1 Cable connection
■ Cable connection
3-22
O P .1
O P .2
!
SAFETY connector
(supplied)
RPB
YAMAHA robot
Advertisement
Chapters
