Wireless Interface Commands - SMC Networks EliteConnect SMC2555W-AG2 User Manual

Example
Enterprise AP#show interface ethernet
Ethernet Interface Information
========================================
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Speed-duplex
Admin status
Operational status
========================================
Enterprise AP#

Wireless Interface Commands

The commands described in this section configure connection parameters for the
wireless interfaces.
Command
interface wireless
vap
speed
turbo
multicast-data-rate
channel
transmit-power
radio-mode
preamble
antenna control
antenna id
antenna location
: 192.168.2.2
: 255.255.255.0
: 192.168.1.253
: 192.168.1.55
: 10.1.0.55
: 100Base-TX Half Duplex
: Up
: Up
Table 7-17. Wireless Interface Commands
Function
Enters wireless interface configuration mode
Provides access to the VAP interface configuration
mode
Configures the maximum data rate at which the
access point transmits unicast packets
Configures turbo mode to use a faster data rate
Configures the maximum rate for transmitting
multicast packets on the wireless interface
Configures the radio channel
Adjusts the power of the radio signals transmitted
from the access point
Forces the operating mode of the 802.11g radio
Sets the length of the 802.11g signal preamble
Selects the antenna control method to use for the
radio
Selects the antenna ID to use for the radio
Selects the location of the antenna
Wireless Interface Commands
Mode
GC
IC-W
IC-W
IC-W (a)
IC-W
IC-W
IC-W
IC-W (b/g)
IC-W (b/g)
IC-W
IC-W
IC-W
7
Page
7-96
7-96
7-97
7-97
7-98
7-99
7-99
7-100
7-101
7-101
7-102
7-103
7-93