SMC Networks EliteConnect SMC2555W-AG2 User Manual page 69

6
System Configuration
• Prevent Inter and Intra VAP client communication: When enabled, clients cannot
establish wireless communications with any other client, either those associated to
the same VAP interface or any other VAP interface.
AP Management Filter – Controls management access to the access point from
wireless clients. Management interfaces include the web, Telnet, or SNMP.
(Default: Disabled)
• Disabled: Allows management access from wireless clients.
• Enabled: Blocks management access from wireless clients.
Uplink Port MAC Address Filtering Status – Prevents traffic with specified source
MAC addresses from being forwarded to wireless clients through the access point.
You can add a maximum of eight MAC addresses to the filter table. (Default:
Disabled)
• MAC Address: Specvifies a MAC address to filter, in the form xx-xx-xx-xx-xx-xx.
• Permission: Adds or deletes a MAC address from the filtering table.
Ethernet Type Filter – Controls checks on the Ethernet type of all incoming and
outgoing Ethernet packets against the protocol filtering table. (Default: Disabled)
• Disabled: Access point does not filter Ethernet protocol types.
• Enabled: Access point filters Ethernet protocol types based on the configuration of
protocol types in the filter table. If the status of a protocol is set to "ON," the protocol
is filtered from the access point.
Note: Ethernet protocol types not listed in the filtering table are always forwarded by the
access point.
Ethernet Type Filter – Enables or disables Ethernet filtering on the port. (Default:
Disabled)
CLI Commands for Bridge Filtering – Use the filter local-bridge command from the
global configuration mode to prevent wireless-to-wireless communications through
the access point. Use the filter ap-manage command to restrict management
access from wireless clients. To configure Ethernet protocol filtering, use the filter
ethernet-type enable command to enable filtering and the filter ethernet-type
6-18