SMC Networks EliteConnect SMC2555W-AG2 User Manual page 133

6
System Configuration
The configuration settings for WPA are summarized below:
WPA and WPA2 pre-shared key only
Encryption: Enabled
Authentication Setup: WPA-PSK, WPA2-PSK, or
WPA-WPA2-mixed
Cipher Suite: WEP/TKIP/AES-CCMP
WPA Pre-shared Key Type: Hex/ASCII
1: You must enable data encryption in order to enable all types of encryption in the access point.
2: Select TKIP when any WPA clients do not support AES. Select AES only if all clients support AES.
CLI Commands for WPA Using Pre-shared Key Security – From the VAP interface
configuration mode, use the auth wpa-psk required command to enable WPA
Pre-shared Key security. To enter a key value, use the wpa-pre-shared-key
command to specify a hexadecimal or alphanumeric key. To view the current
security settings, use the show interface wireless a 0 or show interface wireless
g 0 command (not shown in example).
Enterprise AP(config)#interface wireless g
Enter Wireless configuration commands, one per line.
Enterprise AP(if-wireless g)#vap 0
Enterprise AP(if-wireless g: VAP[0])#wpa-pre-shared-key
passphrase-key agoodsecret
Enterprise AP(if-wireless g: VAP[0])#auth wpa-psk required
Data Encryption is set to Enabled.
WPA2 Clients Mode is set to Disabled.
WPA Clients Mode is set to Required.
WPA Multicast Cipher is set to TKIP.
WPA Unicast Cipher can accept TKIP only.
WPA Authentication is set to Pre-Shared Key.
Enterprise AP(if-wireless g: VAP[0])#
6-82
Table 6-4. WPA Configuration Settings
WPA and WPA2 over 802.1X
Encryption: Enabled
Authentication Setup: WPA, WPA2,
WPA-WPA2-mixed
Cipher Suite: WEP/TKIP/AES-CCMP
(requires RADIUS server to be specified)
7-88
7-125