Iapp Commands; Iapp - SMC Networks EliteConnect SMC2555W-AG2 User Manual

IAPP Commands

The command described in this section enables the protocol signaling required to
ensure the successful handover of wireless clients roaming between different
802.11f-compliant access points. In other words, the 802.11f protocol can ensure
successful roaming between access points in a multi-vendor environment.

iapp

This command enables the protocol signaling required to hand over wireless clients
roaming between different 802.11f-compliant access points. Use the no form to
disable 802.11f signaling.
Syntax
[no] iapp
Default
Enabled
Command Mode
Global Configuration
Command Usage
The current 802.11 standard does not specify the signaling required between
access points in order to support clients roaming from one access point to
another. In particular, this can create a problem for clients roaming between
access points from different vendors. This command is used to enable or
disable 802.11f handover signaling between different access points, especially
in a multi-vendor environment.
Example
Enterprise AP(config)#iapp
Enterprise AP(config)#
7
IAPP Commands
7-131