SMC Networks EliteConnect SMC2555W-AG2 User Manual page 104

CLI Commands for the Configuring the VAPs – From the global configuration mode,
enter the interface wireless a command to access the 802.11a radio interface.
From the 802.11a interface mode, you can access radio settings that apply to all
VAP interfaces. To access a specific VAP interface (numbered 0 to 7), use the vap
command. You can configure a name for each interface using the description
command. You can also use the closed-system command to stop sending the
SSID in beacon messages. Set any other VAP parameters and radio setting as
required before enabling the VAP interface (with the no shutdown command). To
view the current 802.11a radio settings for the VAP interface, use the show
interface wireless a 0 command as shown on 7-95.
Enterprise AP(if-wireless a)#vap 0
Enterprise AP(if-wireless a: VAP[0])#description RD-AP#3
Enterprise AP(if-wireless a: VAP[0])#vlan-id 1
Enterprise AP(if-wireless a: VAP[0])#closed-system
Enterprise AP(if-wireless a: VAP[0])#authentication-timeout-
interval 30
Enterprise AP(if-wireless a: VAP[0])#association-timeout-
interval 20
Enterprise AP(if-wireless a: VAP[0])#max-association 32
Enterprise AP(if-wireless a: VAP[0])#pmksa-lifetime 900
Enterprise AP(if-wireless a: VAP[0])#
Configuring Rogue AP Detection
To configure Rouge AP detection, select the Radio Settings page, and scroll down to
the "Rouge AP" section.
Rogue AP – A "rogue AP" is either an access point that is not authorized to
participate in the wireless network, or an access point that does not have the correct
security configuration. Rogue APs can allow unauthorized access to the network, or
fool client stations into mistakenly associating with them and thereby blocking
access to network resources.
6
Radio Interface
7-95
7-106
7-133
7-107
7-108
7-108
7-108
7-125
6-53