SMC Networks EliteConnect SMC2555W-AG2 User Manual page 285

A
Troubleshooting
3. If you cannot access the on-board configuration program via a serial port
connection:
• Be sure you have set the terminal emulator program to VT100 compatible, 8
data bits, 1 stop bit, no parity and 9600 bps.
• Check that the null-modem serial cable conforms to the pin-out connections
provided on page B-3.
4. If you forgot or lost the password:
• Set the access point to its default configuration by pressing the reset button
on the back panel for 5 seconds or more. Then use the default user name
"admin" and password "smcadmin" to access the management interface.
5. If all other recovery measure fail, and the access point is still not functioning
properly, take any of these steps:
• Reset the access point's hardware using the console interface, web interface,
or through a power reset.
• Reset the access point to its default configuration by pressing the reset button
on the back panel for 5 seconds or more. Then use the default user name
"admin" and a null password to access the management interface.
A-2