Show Hardware; System Logging Commands - SMC Networks EliteConnect SMC2555W-AG2 User Manual

7
Command Line Interface
SSH Server
SSH Server Port
Telnet Server
WEB Redirect
DHCP Relay
==============================================================
Version Information
=========================================
Version: v4.3.2.2
Date : Dec 20 2005, 18:38:12
=========================================
Enterprise AP#

show hardware

This command displays the hardware version of the system.
Command Mode
Exec
Example
Enterprise AP#show hardware
Hardware Version Information
===========================================
Hardware version R01
===========================================
Enterprise AP#

System Logging Commands

These commands are used to configure system logging on the access point.
Command
logging on
logging host
logging console
logging level
logging facility-type
logging clear
show logging
show event-log
7-28
: ENABLED
: 22
: ENABLED
: DISABLED
: DISABLED
Table 7-6. System Logging Commands
Function
Controls logging of error messages
Adds a syslog server host IP address that will receive
logging messages
Initiates logging of error messages to the console
Defines the minimum severity level for event logging GC
Sets the facility type for remote logging of syslog
messages
Clears all log entries in access point memory
Displays the state of logging
Displays all log entries in access point memory
Mode Page
GC 7-30
GC 7-30
GC 7-31
7-31
GC 7-32
GC 7-33
Exec 7-33
Exec 7-34