SMC Networks EliteConnect SMC2555W-AG2 User Manual page 88

Note: The access point also allows you to disable SNTP and set the system clock
manually.
Set Time Zone – SNTP uses Coordinated Universal Time (or UTC, formerly
Greenwich Mean Time, or GMT) based on the time at the Earth's prime meridian,
zero degrees longitude. To display a time corresponding to your local time, you must
indicate the number of hours your time zone is located before (east) or after (west)
UTC.
Enable Daylight Saving – The access point provides a way to automatically adjust
the system clock for Daylight Savings Time changes. To use this feature you must
define the month and date to begin and to end the change from standard time.
During this period the system clock is set back by one hour.
CLI Commands for SNTP – To enable SNTP support on the access point, from the
global configuration mode specify SNTP server IP addresses using the sntp-server
ip command, then use the sntp-server enable command to enable the service. Use
the sntp-server timezone command to set the time zone for your location, and the
sntp-server daylight-saving command to set daylight savings. To view the current
SNTP settings, use the show sntp command.
Enterprise AP(config)#sntp-server ip 1 10.1.0.19
Enterprise AP(config)#sntp-server enable
Enterprise AP(config)#sntp-server timezone +8
Enterprise AP(config)#sntp-server daylight-saving
Enter Daylight saving from which month<1-12>: 3
and which day<1-31>: 31
Enter Daylight saving end to which month<1-12>: 10
and which day<1-31>: 31
Enterprise AP(config)#exit
Enterprise AP#show sntp
SNTP Information
=========================================================
Service State
SNTP (server 1) IP
SNTP (server 2) IP
Current Time
Time Zone
Daylight Saving
=========================================================
Enterprise AP#
: Enabled
: 10.1.10.19
: 192.43.244.18
: 19 : 35, Oct 10th, 2003
: +8 (TAIPEI, BEIJING)
: Enabled, from Mar, 31st to Oct, 31st
Advanced Configuration
7-34
7-34
7-36
7-36
7-37
6
6-37