Show Event-Log; System Clock Commands - SMC Networks EliteConnect SMC2555W-AG2 User Manual

show event-log

This command displays log messages stored in the access point's memory.
Syntax
show event-log
Command Mode
Exec
Example
Enterprise AP#show event-log
Mar 09 11:57:55
Mar 09 11:57:55
Mar 09 11:57:34
Mar 09 11:57:18
Mar 09 11:56:35
Mar 09 11:55:52
Mar 09 11:55:52
Mar 09 11:55:52
Mar 09 11:55:40
Mar 09 11:55:40
Press <n> next. <p> previous. <a> abort. <y> continue to end :
Enterprise AP#configure
Enter configuration commands, one per line. End with CTRL/Z
Enterprise AP(config)#logging clear

System Clock Commands

These commands are used to configure SNTP and system clock settings on the
access point.
Command
sntp-server ip
sntp-server enable
sntp-server date-time
sntp-server
daylight-saving
sntp-server timezone
show sntp
Information: 802.11g:11g Radio Interface Enabled
Information: 802.11g:Radio channel updated to 8
Information: 802.11g:11g Radio Interface Enabled
Information: 802.11g:11g Radio Interface Enabled
Information: 802.11a:11a Radio Interface Enabled
Information: SSH task: Set SSH server port to 22
Information: SSH task: Enable SSH server.
Information: Enable Telnet.
Information: 802.11a:11a Radio Interface Disabled
Information: 802.11a:Transmit Power set to QUARTER
Table 7-7. System Clock Commands
Function
Specifies one or more time servers
Accepts time from the specified time servers
Manually sets the system date and time
Sets the start and end dates for daylight savings time
Sets the time zone for the access point's internal clock
Shows current SNTP configuration settings
System Clock Commands
Mode
GC
GC
GC
GC
GC
Exec
7
Page
7-35
7-35
7-36
7-37
7-37
7-38
7-33