Adjustment - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

6.5.3 Adjustment

The length of the wire isadjusted by screwing
the elbow links in the desired direction. Perform
the adjustment at both links. The links shall be
screwed onto the wire about the same amount.
See "Elbow links" at page 3.
1. Set the rear stop screw in its lowest position.
2. Block up the pedal with a piece of wood or
similar until the pedal rests against its rear
stop. If the pedal doesn´t reach its rear stop,
adjust the elbow links.
3. Check that the pump lever has fully reach its
stop position. If not, adjust the elbow links.
4. Block up the pedal with a piece of wood or
similar until the pedal rests against its front
stop. If the pedal doesn´t reach its front stop,
adjust the stop upwards.
5. Check that the pump lever has fully reach its
stop position. If not, adjust the elbow links.
When the control wire isproperly adjusted, the
following conditions shall be fulfilled:
• Both elbow links shall be screwed onto the
wire ends about the same amount.
• The pedal shall easily reach its rear stop
(moved backwards). Simultaneously shall the
pump lever reach its stop position.
• The pedal shall easily reach its front stop
(moved forwards). Simultaneously shall the
pump lever reach its stop position.
Warning! If the pump lever reach
its stop and the pedal not, abnor-
mal push/pull forces will occour
in the wire. This will limit the wire
durability.
WORKSHOP MANUAL Chapter
6 - Control Wires
EDITION Page
2018 10