Assembly; Replacing The Yoke Shaft - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

2.6.2 Assembly

1. All the assembly is performed in the reverse
order.
2. Note the support sleeve between the spheric
plain bearings,
3. Lubricate the spheric plain bearings before
installation.

2.6.3 Replacing the yoke shaft

1. Apart the art. point as described in "Articulat-
ing point" page 15.
2. Use an angle grinder and cut the yoke shaft
close to the rear bearing. See the figure.
3. Grind off the painting from the rear part of
the shaft and pull out the pieces backwards.
4. Turn the front part of the shaft until the dowel
can be forced out and dismantle the parts.
5. The new yoke shaft is assembled in the
reverse order.
6. Note that the bearing surfaces shall be lubri-
cated before installation.
WORKSHOP MANUAL Chapter
2 - Chassis and body
EDITION Page
2018 16