Choke Wire; Smontaggio - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

6.4 Choke wire

6.4.1 Smontaggio

1. Dismantle the upper and lower front engine
covers. See "Front engine covers" at page 5
in "2 Chassis".
2. Dismantle the outside instrument cover. See
"Instrument covers" at page 10 in "2 Chas-
sis".
3. Cut the holding straps (A) and note their
location for the assembly purpose.
4. Dismantle the lower instrument cover (B) by
loosening its four screws.
5. Loosen the nut at the rear of the engine and
hook off the wire.
6. Push out the choke wire wire from the holder
at the articulating point.
7. Loosen the knob nut, located under the
panel.
8. Work the entire wire forwards and take it out
through the panel mounting hole.
WORKSHOP MANUAL Chapter
6 - Control Wires
EDITION Page
2018 7