General Measures; Elbow Links - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

6.2 General measures

6.2.1 Elbow links

In many cases there are elbow links mounted at
the wire ends. The elbow links have two func-
tions as follows:
• To transmit the movement to/from the actual
lever.
• For wire adjustment purpose. The wire ten-
sion is adjusted by screwing the link on/off the
threaded rod at the wire.
Note! At the adjustment, at least 5
threads shall be engaged.
To change an elbow link
1. Loosen the nut (3) with a 8 mm wrench.
2. Remove the nut (1) with a 8 mm wrench.
Hold the elbow stud with a 7 mm wrench.
3. Screw the elbow link off the rod.
4. The assembly is performed in the reverse
order.
5. After the assembly, adjust the wire.
To apart an elbow link
1. Fold up the circlip (4) from the elbow link
body.
2. Pull out the circlip.
3. Pry off the link body from the stud sphere by
help of a screwdriver or similar.
4. The assembly is performed in the reverse or-
der. The link body is pressed onto the sphere
by help of a polygrip or similar.
Note! It is important that the circlip (4) is
inserted in both holes in the elbow link
body, otherwise the link will separate dur-
ing operation.
WORKSHOP MANUAL Chapter
6 - Control Wires
EDITION Page
2018 3