PARK PRO 540 IX - 740 IOX
2.5 Steering cylinder
2.5.1 Dismantling
1. Block up the machine. Use a lifting table or
highjack and yokes.
2. Activate the parking brake.
3. Dismantle all covers at the left side. See
"Covers" page 5.
4. Block up the front left wheel and remove it to
get access to the front cylinder attachment.
5. Place a collecting tray under the steering
servo for collecting residual oil from the
hoses.
Warning! Do not spill any oil on the
drive belts during the disconnec-
tion of hoses and tubes.
Warning! Keep clean when han-
dling hydraulic parts. Dirt in the oil
will cause malfunctions and break-
downs.
6. Dismantle the hose collecting bar (A).
7. Loosen the cylinder hoses (B) from the
steering servo.
8. Remove the screws holding the steering cyl-
inder and take out the cylinder with hoses.
9. Note the angle of the hoses and remove
them from the cylinder. Fit the hoses in the
same angle to the new cylinder.
2.5.2 Assembly
1. All the assembly is performed in the reverse
order.
2. After the assembly, start the machine and
turn the steering wheel fully left and fully right
several times until the steering works prop-
erly.
3. Check the hydraulic oil and fill up as neces-
sary. See the owners manual.
WORKSHOP MANUAL
Chapter
2 - Chassis and body
EDITION
Page
2018
14