Change Of Transmission Oil - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

4.8 Change of transmission oil

The oil and the filter in the hydraulic power
transmission must be checked/adjusted or re-
placed at intervals according to the table below.
Action
Check -adjusting level
Changing oil - Replace
filter in the hydraulic
circuit
Oil type: Synthetic oil 5W-50.
Oil volume at change: approx. 4.7 litres.
Check – adjustment
1. Place the machine on a flat surface.
2. Read off the oil level in the reservoir. See the
figure. The level should be level with the line.
3. If necessary, top up with more oil.
Draining
1. Operate the machine at varying speeds for
10-20 minutes in order to warm up the trans-
mission oil.
2. Open the drive shafts' valves in accordance
with the figure.
3. Place one collection trough under the rear
axle and one under the front axle.
4. Remove 2 drainage plugs from each axle.
Use a 12 mm socket wrench. See the figure.
5. Remove the filler cap from the oil tank.
WORKSHOP MANUAL
1.st Then at
time interval
Hours of
operation
-
5
Chapter
4 - Hydraulic system
50
200
EDITION Page
2018 24