Lubrication - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

2.2 Lubrication

The lubrication must be performed in accord-
ance with the service schedule. See the main-
tenance manual delivered with the machine.
Note! Lubrication is equally important
for a machine that is only used for a few
hours per year.
Note! The lubricant provides not only
protection from wear but also from rust.
Note! The machine should always be
lubricated before prolonged storage.
The lubrication is described in the table below
and in the figure at the next page.
Object
Centre point
Steering wheel
(740 IOX, 540 IX)
Tensioning arms
Wheel bearings
Quick-release sup-
ports
Control cabìes
WORKSHOP MANUAL
3 grease nipples located on the central articulation on
the left-hand side of the machine.
Use a grease gun filled with universal grease.
Pump until the grease seeps out.
2 grease nipples located on the central articulation on
the left-hand side of the machine.
Use a grease gun filled with universal grease.
Pump until the grease seeps out.
Lubricate the support points of the tensioning arms
with oil.
2 grease nipples.
Use a grease gun filled with universal grease.
Pump until the grease seeps out.
1 grease nipple for each front wheel.
Use a grease gun filled with universal grease.
Pump until the grease seeps out.
Lubricate the control cable ends with oil.
Chapter
2 - Chassis and body
Action
EDITION Page
2018 3
Pos.
A
B
C
D
E
F