Covers Around The Articulating Point - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX
Warning! Don´t try to remove the
cover without dismantle the tank.
This will destroy both the cover and
the seat bellow.
Warning! Petrol is highly inflammable.
The fuel cap must be on and tight
when moving the tank..
3. Move the cover forwards until the tank at-
tachment wing nuts are free and remove the
nuts.
4. Place the tank upon the engine and remove
the cover.
5. Assemble the cover in the reverse order.
6. Important steps during the assembly of
the lower cover and the tank:
First set the cover in place without fasten it
with its screws.
Then set the tank in place and fasten it with
its attachments.
Finally fasten the lover cover with its two
screws.
2.3.2 Covers around the articulating
point
Dismantling
Dismantle the covers around the articulating
point as follows:
1. Unscrew the two M6 nuts, one at each side
and remove the protecting bar. Use a mirror
to locate the nuts.
WORKSHOP MANUAL
IMPORTANT - Carefully check that the positive wires (red)
are integral, that the insulation is not cracked or worn and
that the corrugated protection sheath is installed and cor-
rectly mounted to prevent cables from being crushed by
the battery housing after installation.
For machines without corrugated protection sheath, this
must be installed following the instructions provided (see
7.9).
Chapter
2 - Chassis and body
EDITION Page
2018 6