Unpacking And Assembly; General; Tyres - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX
1.3 Unpacking and
assembly

1.3.1 General

Every machine has undergone an exten-
sive control programme before delivery.
The machines are delivered as completely
assembled as possible.
Thanks to this the assembly on delivery is
rapid and easy.
The correct and careful assembly of the
machine on delivery is asimple way of
ensuring satisfied customers!
A complete assembly instruction is given
in the owners manuat delivered with the
machine. This section will give comple-
ment information and explanations for the
assembly.
Note! The machine shall remain
placed on the pallet during the un-
packing and assembly.

1.3.2 Tyres

Check the air pressure in the tyres. The
pressure is designated on the floor mat.
The air pressure in the tyres is of critical
importance for the performance and han-
dling of the machine. The correct air pres-
sure for mowing is 0.6 bar (9 psi) in the
front tyres, and 0.4 bar (6 psi) in the rear
tyres.
When using heavy accessories, e.g. snow
thrower, it may be necessary to increase
the pressure somewhat. However, the
maximum permitted pressure is always 0.8
bar (12 psi).
Too high pressure in the tyres leads to that
the machine drives poor due to: i:
• A small surface in contact to the
ground.
• Hard tyre = less flexibility = self clean-
ing characteristic deteriorate.
WORKSHOP MANUAL Chapter
1 - General instructions
Too high
pressure
EDITION Page
2018 4
Correct
pressure