Hst Control Wire; Dismantling; Assembly - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

6.5 HST control wire

6.5.1 Dismantling

1. Dismantle the upper and lower front engine
covers. See "Front engine covers" at page 5
in "2 Chassis".
2. Loosen the elbow links front and rear from
their levers. See "Elbow links" at page 3.
3. To make it easier to take out the wire, un-
screw the rear elbow link from the rod.
4. Loosen the conduit attachments front and
rear and draw out the wire forwards.

6.5.2 Assembly

1. Fit the new wire in the same location as the
old one.
2. Check the elbow links for damage or wear.
Replace with new links if necessary. Fit the
elbow links with their locking nuts at the wire
ends. See "Elbow links" at page 3. The links
shall be screwed onto the wire ends about 1
cm.
3. Fit the new wire.
Note! The longer rod tube shall be
located forwards.
IMPORTANT NOTE - For machines built
after 2014 until November 2019, make
sure all the latest updates for HST drive
cable supports, illustrated in the figure,
have been introduced, to eliminate any
faults found in use. Should these up-
dates not have been implemented, THEY
MUST be performed using the specific
kits and following the relevant assembly
instructions.
4. Fit the front and rear clamps. Make sure that the dogs at the clamps fit in the grooves in
the wire cover. Both front and rear. Se the figure.
5. Fit the elbow links to the levers.
6. Adjust the control wire as described below.
WORKSHOP MANUAL Chapter
6 - Control Wires
EDITION Page
2018 9