Assembly; Adjustment - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX

6.4.2 Assembly

1. Assemble the choke wire in the reverse
order.
2. Drop a few drops oil at the wire ends and
move the wire som strokes in its housing.
3. Install new holding straps where the previous
was cut.

6.4.3 Adjustment

1. Tighten the sleeve holding screw (A) very
light.
2. Actuate the choke knob and check that the
engine choke lever can reach its end posi-
tions. Check also that the choke knob can be
forced fully into its end down position.
3. Tighten the sleeve screw (A).
WORKSHOP MANUAL Chapter
6 - Control Wires
EDITION Page
2018 8