PARK PRO 540 IX - 740 IOX
2.6 Articulating point
2.6.1 Dismantling
1. Block up the machine. Use a lifting table or
highjack and yokes.
2. Activate the parking brake.
3. Dismantle all covers from the art. point. See
"Covers" page 5.
4. Turn the steering wheel max to the left and
loosen the rear steering cylinder attachment.
5. Work off the belts from the art. point pulley,
unscrew the lower screw and remove the
pulley from its shaft.
Warning! Check that the frames are
securely supported while they are
separated.
6. Support the front and rear frame close to the
art. point with two hydraulic jack or similar.
7. Unscrew the upper screw and press the
shaft downwards and separate the frames.
8. Move the rear frame sideways until it comes
free from the fork.
9. Press out the two spheric plain bearings
from the rear frame. Use a mandrel if neces-
sary.
WORKSHOP MANUAL
Chapter
2 - Chassis and body
EDITION
Page
2018
15