Assembly; Adjustment - Stiga PARK PRO 540 IX Workshop Manual

PARK PRO 540 IX - 740 IOX
7. Press out the front sleeve from its holder.
Use a screwdriver.
8. Work the entire wire forwards and hook it off
the throttle lever and take it out.

6.3.2 Assembly

1. Assemble the throttle wire in the reverse
order.
2. Drop a few drops oil at the wire ends and
move the wire some strokes in its housing.
3. The front sleeve can be forced into place
with help of a polygrip pliers.
4. Install new holding straps where the previous
was cut.

6.3.3 Adjustment

1. Tighten the sleeve holding screw (A) very
light.
2. Set the throttle lever in its idling position.
3. Start the engine and adjust the sleeve until
the engine rpm shall start to increase.
4. Tighten the sleeve screw in a position where
the engine rpm still is idling.
WORKSHOP MANUAL Chapter
6 - Control Wires
EDITION Page
2018 6