PARK PRO 540 IX - 740 IOX
1.2.1 Symbols and general
warnings
Warning! This symbol indicates
a risk of personal injury or dam-
age if the instructions are not
followed.
Note! This text indicates a risk of
damage to the material or risk of un-
necessarily complicated work if the
instructions are not followed.
1.2.2 Warm parts
Please observe that engine and exhaust
system picks up a lot of heat during use.
To avoid injuries, allow the machine to cool
before any kind of repairs are made to or
near parts of the engine or exhaust sys-
tem.
1.2.3 Moving parts
The machines are all equipped with v-belt
transmissions. Always stop the engine and
remove the starter key before inspections
or repairs are carried out.
Always use extreme caution when testing
systems with moving parts to avoid inju-
ries.
Always use Genuine Spare Parts during
service work.
1.2.4 Lifting and blocking up
Before work under the machine, always
make sure that lifting devices and jack-
stands are approved for the weight.
Work safe!
WORKSHOP MANUAL
Chapter
1 - General instructions
1.2.5 Cleanliness
Clean the machine before starting repairs.
Dirt that penetrates into sensitive compo-
nents can seriously influence the service
life of the machine.
1.2.6 Tightening torque
Unless otherwise stated the tightening
torque in the tables in the section Technical
specifications must be used for the differ-
ent sizes of screws.
This does not refer to self-tapping screws,
which are mainly used for the assembly of
body parts.
1.2.7 Sharp edges
Watch out for sharp edges, especially
when working with the mower deck. The
blades can be very sharp. Always wear
gloves when working with the blades.
1.2.8 Replacement parts
Always use Genuine Spare Parts during
service work.
1.2.9 Inspection
Each part dismantled in conjunction with
service work must be inspected.
Examine for: wear, cracks, out of round-
ness, straightness, dents, discolouring,
abnormal noise and jamming.
EDITION
Page
2018
3