Mitsubishi CR800 Series Instruction Manual page 49

Error No.
L3200 Error message This file is read only
Cause
Measures
L3210 Error message This variable is write protected
Cause
Measures
L3220 Error message Nesting over
Cause
Measures
L3230 Error message For Next statements unmatch
Cause
Measures
L3240 Error message Nesting over (For, While)
Cause
Measures
L3250 Error message While WEnd statements unmatch
Cause
Measures
L3251 Error message Number of jump destination exceeds 32
Cause
Measures
L3252 Error message If EndIf statements unmatch
Cause
Measures
L3253 Error message Nesting over (If, EndIf)
Cause
Measures
L3254 Error message Select - End Select statements unmatch
Cause
Measures
L3255 Error message If Else statements unmatch
Cause
Measures
The file cannot be read.
Check the contents of the file.
Writing of this variable is prohibited.
Check the variable protection setting.
A nest-over error occurred in If of the If instruction or For of the For instruction.
Correct the program and re-execute.
The No. of For and Next statements do not match.
Correct the program and re-execute.
Nesting over (For, While)
Correct the program and re-execute.
The No. of While and WEnd statements do not match.
Correct the program and re-execute.
The number of branches defined exceeded 32.
Correct the program and re-execute.
If EndIf statements unmatch.
Correct the program and re-execute.
Nesting over (If, EndIf)
Correct the program and re-execute.
Select - End Select statements unmatch.
Correct the program and re-execute.
If Else statements unmatch.
Correct the program and re-execute.
Error cause and measures
1Error list
1-40
Error no. L3200