Mitsubishi CR800 Series Instruction Manual page 60

1Error list
Error No.
L4370 Error message Error in the array element
Cause
Measures
L4380 Error message Cannot delete variables (used)
Cause
Measures
L4390 Error message Variable type combination error
Cause
Measures
L4400 Error message Program is faulty.
Cause
Measures
L4420 Error message Line No exceeds 32767
Cause
Measures
L4430 Error message Not found the string searched
Cause
Measures
L4440 Error message Duplicate definition (label)
Cause
Measures
L4460 Error message Argument value range over
Cause
Measures
L4470 Error message Line No can't be used
Cause
Measures
L4800 Error message System error (System base prog)
Cause
Measures
L4810 Error message The global variable defined by user is not available
Cause
Measures
L4811 * Error message The global variable redefined
Cause
Measures
L4820 Error message No editing program
Cause
Measures
L4900 Error message System error (Prog Hndl)
Cause
Measures
L4910 Error message Robot Language is mismatched
Cause
Measures
1-51
Error no. L4370
1. The array elements exceeds the define range.
2. The specified variable is not an array.
1. Correct the number of array elements within one to the maximum elements.
2. Do not specify array elements.
Variables used in a command statement cannot be deleted.
Delete the command statement using the variable.
The type of the user-defined external variable is different.
Match the variable types.
The content of the program is abnormal.
Delete the program.
The new line No. or line gap is large.
Do not use line No. exceeding 32767.
The character string searched for was not found.
Check the program.
A label already defined cannot be redefined.
1. Change the label name.
2. Delete the defined label line.
Argument value range over.
Confirm the argument range, and correct the value.
Line No can't be used
Please use the label
The base program for the system could not be opened. Or, the system base program name was not speci -
fied correctly in the parameter.
If it comes back, contact your service provider.
The parameter "PRGUSR" is not correct.
To use user-defined external variables, it is necessary to set the name of the program describing only
variable definitions in the PRGUSR parameter.
A system global variable is defined in user global.
Correct the program.
The program was closed while editing. For example, the program being edited is closed when a key switch
enable/disable operation is performed via the T/B during online editing on a PC.
Try editing the program again.
The program name used by internal processing is not normal.
If it comes back, contact your service provider.
The parameter RLNG is mismatched. (2:MELFA-BASIC V, 3:MELFA-BASIC VI)
Re-set RLNG or select an other program.
Error cause and measures