Mitsubishi CR800 Series Instruction Manual page 11

Error No.
H0006 * Error message CPU process error
Cause
Measures
H0008 * Error message CPU synchronization error
Cause
Measures
H0009 * One of the errors below is detected.
Please take measures corresponding to an error message.
Error message Version UP (ALL)
Cause
Measures
Error message Version UP (MAIN)
Cause
Measures
Error message Version UP (SERVO)
Cause
Measures
Error message The servo s/w was written
Cause
Measures
Error message Rewriting failed servo(Er.*)
Cause
Measures
C0010 Error message Illegal Version (file)
Cause
Measures
C0011 Error message Illeagal Version (system data)
Cause
Measures
C0012 Error message Initialize (error log)
Cause
Measures
C0013 * One of the errors below is detected.
Please take measures corresponding to an error message.
Error message Illeagal file
Cause
Measures
Error message Illegal system SD card
Cause
Measures
H0014 * Error message System error (illegal MECHA)
Cause
Measures
H0015 * Error message Illeagal Version (file)
Cause
Measures
CPU was not normally treatable
It is necessary to change some parts when not improvement.
* The "CPU" part in each message varies according to the CPU in which an error is detected.
RCPU_main, CCPU_main, RCPU_sub, CCPU_sub, CPU_main, CPU_sub, FPGA
CPU synchronization was failed
Turn the power OFF and ON once.
Version UP (ALL)
Turn the power OFF and power ON once
Version UP (MAIN)
Turn the power OFF and power ON once
Version UP (SERVO)
Turn the power OFF and power ON once
The servo s/w was written
Please release an error by reset operation
* This error can be reset without turning on the power supply again.
Servo S/W couldn't be read.
When it occurs, contact your service provider
* The number (1 to 7) which indicates the cause of the error is shown in "*" in the error message.
The version is inconsistent.
The file has been automatically initialized. The program is being deleted.
The version is inconsistent.
The file has been automatically initialized. Turn the power OFF and ON once.
The error log has been initialized because of version mismatch or the error log file is abnormal.
Reset the alarm, and continue the operation.
Data including programs may have been damaged.
Contact your service provider as the initialization operation is required.
File Crash
File Initial operation
A character string cannot exceed 14 characters.
Re-input the correct name.
Illeagal Version (file)
Contact the maker.
Error cause and measures
1Error list
1-2
Error no. H0006 *