Running The Quick Install Wizard - Nortel CallPilot Mini Quick Start Manual

12 Initializing the CallPilot Mini
Changing the IP address using an Ethernet crossover cable
Using an Ethernet crossover cable, you can connect the CallPilot Mini to your computer. With this
connection, you can use CallPilot Manager to change the CallPilot Mini IP address before you
connect it to the network.
Note: If you do not have access to the CallPilot Mini through the network, you can use an
Ethernet crossover cable to configure all of the CallPilot Mini parameters.
To use an Ethernet crossover cable, your computer must be equipped with a 10/100 BaseT
Ethernet card and support TCP/IP protocol.
Connecting the Ethernet crossover cable
1 Shut down the computer.
2
Attach one end of the Ethernet crossover cable to the Ethernet port on the CallPilot Mini.
3
Connect the other end of the cable to the network interface card on your computer.
4 Start the computer.
5 Use the Quick Install Wizard to initialize the CallPilot Mini.
For information about how to use the Quick Install Wizard, refer to
Wizard" on page

Running the Quick Install Wizard

The Quick Install Wizard appears the first time you startup CallPilot Manager. The Quick Install
Wizard is a single page that gathers enough information to set up a working system. It then applies
the information and restarts the system.
You can reach CallPilot Manager from another computer through a LAN connection, WAN/
Internet connection or an Ethernet crossover cable. All of these methods create an IP connection
that allows you to run CallPilot Manager.
Use the following procedure to run the Quick Install Wizard:
1 Launch your browser.
2
In the URL address box, type the CallPilot Mini IP address.
For example: HTTP://192.168.110.10
Note: You must include HTTP:// to access CallPilot Manager.
The Quick Install Wizard screen appears. Depending on your system, this can take several
minutes to appear.
P1002915 Issue 01
12.
"Running the Quick Install