Operations, Administration And Maintenance (Oam); Software Upgrade Procedures; Bootloader Upgrade; Callpilot Mini 1.6A Service Update Software Upgrade From Ata Flash - Nortel CallPilot Mini Release Note

3 Operations, Administration and Maintenance (OAM)

3.1 Software Upgrade Procedures

3.1.1 Bootloader Upgrade

To verify the Bootloader version the CallPilot Mini must be connected via serial cable to a
Personal Computer running a terminal emulation package.
CP Mini s/w version
CP 16.00.23.22
** The 1.5.21 version of the bootloader contains a fix to activate the Ethernet LEDs during boot
up. It is not necessary to upgrade to the 1.5.21 bootloader unless this fix is required for the
aforementioned CallPilot Mini s/w versions.
3.1.2 CallPilot Mini 1.6a Service Update Software Upgrade from ATA
Flash Card
Note: When upgrading software within the CallPilot Mini 1.6 stream, it is not necessary to utilize a
serial connection. If for any reason it becomes necessary to view the upgrade messaging, use the
serial connection setup shown here.
The software upgrade procedures are described in the CallPilot Mini Installation and Maintenance
Guide.

3.2 Changing Hardware Parameters

It is not normally necessary to modify the hardware parameters via the CallPilot Mini serial port. If
it is required to change the hardware parameters via the serial port then please follow the
following procedures.
CallPilot 150 Boot Loader V1.5.21
(C) 2001 Nortel Networks
--------------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.110.10
LAN interface's subnet mask is 0xffffff00
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
This board's ethernet address is 0:60:38:BF:0:AA
CALLPILOT BOOTLOADER PARAMETERS:
Execution Mode: Load CallPilot
Source File System Parameters:
Device: ATA Disk
Source File List Name: filelst.lst
Destination File System Parameters:
Device: ATA Disk
File List Name: filelst.lst
Format Target Device: Y
Boot File Name: CallPilot.bin
After board is reset, start-up code will wait 2 seconds
--------------------------------------------------------------------------
To change any of this, press any key within 2 seconds
Issue 1.3
Bootloader shipped
with s/w version
1.5.21 **
CallPilot Mini v1.6a Service Update
Release Notes
Minimum Bootloader
version
1.5.19
Page 8 of 15