Working With The Channel Monitor - Nortel CallPilot 202i Maintenance And Diagnostics

66 Chapter 5 Using CallPilot Manager to monitor hardware
4

Working with the Channel Monitor

The Channel Monitor shows the status of call channels. The call channels
are the connections between the server and the switch that carry the call
signals to CallPilot.
To view or work with call channel states
Step
1
2
Copyright © 2009, Nortel Networks
.
IF you want to stop or start
All of the channels associated with
a DSP.
Only one or several channels that
are associated with a DSP.
Click Courtesy Stop, Stop, or Start as required.
If you clicked Courtesy Stop or Stop, you are asked to confirm the
courtesy stop or stop; click OK.
The selected channels change to off-duty or on-duty status,
according to the action you chose.
Note: If the buttons are not available, wait a few seconds for the
page to refresh.
Action
Run CallPilot Manager and log on.
In CallPilot Manager, click Maintenance, Channel Monitor.
The Channel Monitor page appears, showing the DS30X (also
known as DS0) channels associated with each DS30X link.
Nortel CallPilot
202i Server Maintenance and Diagnostics
NN44200-708 01.02 Standard
5.0 11 August 2009
THEN
Check the check box to the left of
the DSP that you want to stop or
start.
Repeat this step for each DSP.
Check the check box for each
channel that you want to stop or
start.
—End—