Placing A Host-Controlled Call; Placing An Outgoing Locally Controlled Call - Nortel Remote Gateway 9110 Installation And Administration Manual

Using the digital telephone
method 2: Press a calling key.
Pressing a host calling key initiates a host-controlled call. Pressing the local
calling key, initiates a locally controlled call.

Placing a host-controlled call

To place a host-controlled call:
1 Lift the telephone handset or press the host calling key.
Result: You hear a dial tone over a connection with the host PBX.
Note: If a connection to the host PBX cannot be established within a time-
out period or no resources are available to carry the call, you hear a reorder
dial tone (fast busy signal), and one of the following messages appears on
the telephone display:
Bandwidth limit indicates that there was not enough bandwidth available in
the system to complete the requested task.
DSP limit indicates that there were not enough available DSP resources in
the system to complete the requested task.
2 Dial the number of the party you want to call.
Result: The host PBX receives and processes the dialed digits, and rings
the called party.

Placing an outgoing locally controlled call

To place an outgoing locally controlled call:
1 Lift the telephone handset, then press the local calling key.
Result: A connection is established with the central office and you hear a
dial tone.
2 Dial the number of the party you want to call.
Result: Your local telephone service provider receives and processes the
dialed digits, and rings the called party.
140
Release and Try Again
Bandwidth Limit
DSP Limit
Remote Gateway 911x Series Installation and Administration Guide
Standard 3.0