Nortel Remote Gateway 9110 Installation And Administration Manual page 118

Configuring the 911x unit using the telephone menu
IF you want to
change settings
that dictate the
way this Remote
Gateway 911x
series unit places
PSTN calls that
are not controlled
by the host PBX,
not enable this
Remote Gateway
911x series unit to
place calls that
are not controlled
by the host PBX,
enable this
Remote Gateway
911x series unit to
place calls that are
not controlled by
the host PBX,
enable users of
this Remote
Gateway 911x
series unit to put
an active call on
hold without
pressing the Hold
key by pressing
the Local calling
key to answer a
local call,
94
THEN do the following:
1 Press 1.
2 Press the Hold key.
Result: The telephone display asks if you want to
enable this Remote Gateway 911x series unit to
place calls without involving the host PBX, similar to
the following:
Enable Local Calling?
[1-Yes 2-No]
1 Press 2.
2 Press the Hold key.
3 Proceed to step on page 95.
1 Press 1.
2 Press the Hold key.
Result: The telephone display asks if you want to
enable Auto-hold, similar to the following:
Enable Auto-Hold?
[1-Yes 2-No]
1 Press 1.
2 Press the Hold key.
Result: The telephone display prompts you for the
key position of the Local calling key. The telephone
display also shows the current key position for the
Local calling key, similar to the following:
Enter Key Position
5
3 Press the digit of the new Local calling key position.
4 Press the Hold key.
Remote Gateway 911x Series Installation and Administration Guide
Standard 3.0